Equipment and HVAC base foundations on screw piles
Bases and supports for HVAC, units and technical equipment, installed securely and aligned with precision.
Suitable for
Concrete scenarios where this solution works well.
Outdoor air-conditioning unit
A stable, anti-vibration support for air-conditioning units or heat pumps, on the ground or on a roof.
Generator unit
A rigid, levelled and anchored base for generators, with no movement at start-up and free technical access on the side.
Heat pump or geothermal unit
A support sized for the weight and vibration of the equipment. Precise laser alignment for correct connection.
Charging station or outdoor electrical equipment
A stable, levelled base for EV charging stations, outdoor cabinets or monitoring equipment.
What’s included
What you get when you work with Martetic on this solution category.
- Site assessment and equipment specifications
- Load calculation and choice of support type
- Installation of steel support or point foundation
- Laser levelling and anchoring of the equipment
- Stability check and handover
How it works
The main steps from order to handover, for this category.
Equipment specifications
Weight, dimensions, vibration requirements and technical access: we take everything into account.
Choice of support
Adjustable steel support, point foundation or rigid frame, depending on the equipment and site.
Installation and alignment
We install the support, level it with a laser and anchor the equipment according to specifications.
Verification and handover
We test stability and technical access. We hand over ready for the installer to connect.
Advantages
What makes this solution better than the classic alternatives.
Precise alignment
Laser levelling ensures the equipment sits correctly from the start. You avoid vibration and premature wear.
Stable under vibration
The supports are sized to absorb the equipment's vibration without transmitting it into the structure or the ground.
No mandatory concrete
We use screw foundations or adjustable supports: fast, with no curing period, relocatable.
Technical access preserved
We design the support so that service access is clear on all relevant sides.
Products that may be considered
The options below are a starting point. The final selection is confirmed after the structure, ground, loads, connection and installation conditions.
M89, M114, V114 or Custom, depending on weight and vibration
What you need to send us
The location, dimensions, the sketch or plan, known weight or loads, photographs of the ground and the desired deadline.
What we check
The ground, access, bearing points, the connection to the structure, vertical and lateral loads and the possibility of installation.
Frequently asked questions
What customers usually ask about this category.
It depends on the support configuration. We size for the specific weight of your equipment, from 50 kg to several tonnes for large units.
Yes, if we use adjustable supports. We specify this in the design if it is a requirement.
Yes. On a roof we use supports with a distributed base or specific anchors, without perforating the waterproofing membrane where possible.
A simple support for an outdoor unit: 1–2 hours. For several units or complex configurations: half a day or more.
Access with a light vehicle and the ability to work near the installation point. We assess from the start whether lifting equipment is needed.
Related guides
- How to Install Screw Piles: Steps, Torque & Checks
How screw piles are installed: machinery, steps, depth and verticality checks, how long it takes and what is verified before the building goes up.
- Are Screw Piles Certified? CE, DoP, EN 1090, EPD
What CE, DoP, EN 1090, ISO 1461 and EPD mean for screw piles and which documents you should receive for the product and its installation.
Describe your project
Tell us what you want to install and where. You receive a clear proposal with options.
No obligations. No hidden costs.
Request a proposal